Network Setup

The default configuration for the firmware is no DHCP for IP address assignment and static IP address of 192.168.2.10. You will need to configure your network interface to be on the 192.168.2.XXX subnet:

$ ip addr show <Network_Interface>
<Network_Interface>: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 9000 qdisc mq state UP group default qlen 1000
    link/ether 00:1b:21:bd:40:22 brd ff:ff:ff:ff:ff:ff
    inet 192.168.2.1/24 brd 192.168.2.255 scope global noprefixroute <Network_Interface>
       valid_lft forever preferred_lft forever

The RUDP streaming interface uses JUMBO Ethernet frames. You will need to make sure that you configure your network interface to enable jumbo frame support. If your RUDP Ethernet traffic goes through any Ethernet switches or routers, you will need to enable jubmo frame support for those devices as well.

$ sudo ip link set dev <Network_Interface> mtu 9000